formlabs Form Cure L, Инструкция по установке и использованию

Страница: 15 / 40

Safety | 13
• Always disconnect power before cleaning.
• Only use well-maintained equipment.
• Operate on a clear and level surface.
Do not touch hot surfaces. The Form Cure L contains two 500 W heaters to help
ensure parts are strong after post-curing. While the heater and fan designs limit
overheating and the heater is insulated to contain heat, surfaces of the Form Cure
L and printed parts may be hot during and after use.
Like any heating appliance, a fire may occur if the Form Cure L maintains extended
contact with flammable materials, such as walls or curtains. Keep the Form Cure L
away from walls and curtains. Keep the area surrounding the turntable clean, and
only post-cure parts that have been completely dried. Accumulation of cured material
creates the possibility of malfunction.
The Form Cure L uses heat as well as 375 nm and 405 nm light to post-cure 3D printed parts.
The door includes an interlock system that is designed to automatically pause heating and
extinguish the cure lights when the door is open.
3.1.2 Resin
Resin and solvents may cause skin irritation or an allergic skin reaction. Wear
gloves when handling liquid resin, liquid solvent, or resin-coated surfaces. Wash
skin with plenty of soap and water. Do not use alcohol or other solvents to
remove resin from skin.
Consult the safety data sheet (SDS) as the primary source of information to
understand safety and handling of Formlabs resins. Respect Formlabs resin like any
household chemical. Follow standard chemical safety procedures and Formlabs resin
handling instructions. In general, Formlabs resin is not approved for use with food,
drink, or medical applications on the human body. Refer to the safety data sheet (SDS)
for each specific resin as well as support.formlabs.com for more detail.
3.1.3 Optical radiation
This equipment has been tested and found to be exempt from classification pursuant to
IEC 62471.
3.1.4 Radio interference
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to CFR Title 47, Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at their own expense.
CAUTION
CAUTION
WARNING
NOTICE