Safety Precautions
To avoid personal injury, and damage to the shredder, observe the following safety
precautions. Please keep these instructions for future reference.
• Keep hands, long hair, clothing, ties, jewelry and other loose items away from the paper
entrance and shred outlet.
• Do not use the shredder for anything other than its intended purpose. Never use it to shred
cloth, plastic, cardboard or any hard material that will cause damage to the shredder blades.
• Do not allow children to use the machine.
• Do not operate with a damaged power cord or plug, or when the machine is damaged in
any manner.
• Unplug the shredder when it is being moved, or if it is not in use for an extended period of
time.
• Do not disconnect the power by pulling only the cord. Hold the plug when disconnecting.
• Keep the shredder away from direct sunlight.
• In case of emergency, push the
OFF
button, or pull the plug out of the wall outlet.
FD 8202CC Cross-Cut
Deskside Shredder
OPERATOR MANUAL
SECOND EDITION
3-2011
Overload Protection
To prevent damage of the shredder, the motor has been equipped with a thermal overload
mechanism. This makes the unit inoperative for a short period of time if it becomes too
warm. If this occurs, it is necessary to turn off and unplug the unit for at least 20 minutes
before using it again.
Clearing Paper Jams
A paper jam may occur in the following situations: exceeding the recommended sheet
capacity, paper is too wide for the infeed, or if paper is not fed squarely into the infeed. To
protect the unit from damage, it is equipped with an auto shut-off, in the event of overload.
To clear the jam, follow these instructions:
1. Press the Control switch to the “
R”
position until the paper is cleared.
2. Press the Control switch to the “
O”
position.
3. To resume normal operation, press the Control switch to
“I”
position.
CAUTION:
If the reverse action does not clear the jammed paper, DO NOT ATTEMPT TO
OPEN THE MACHINE HOUSING. Contact your Formax Dealer for service.
IMPORTANT! Oiling Instructions
After 15 to 30 minutes of continuous use, the cutting cylinders must be oiled. To do this,
run the shredder in reverse and squirt oil the length of the cutting cylinders twice.
OILING
AND REVERSING
the cutting cylinders is critical to maintain life expectancy and sheet
capacity of the shredder. Contact your Formax Dealer to order shredder oil, part #8000-10.
