Working with Jobs
3
Introduction
With the system you can process mail sets in the following ways:
• Using an existing (saved) job: Existing jobs are shown in the Job list. These jobs
have been saved via the job creation process.
• Using a new, unsaved job: after tapping the [New Job] button and finishing the Job
Wizard just tap the start button. It is not needed to save the job first.
Use an existing job
Before you use an existing job where sealing is required, make
sure the sealing liquid reservoir is filled.
To use an existing job:
1.
From the home screen choose a job. The job information appears, see “
on page 9".
2.
Load envelopes as specified in the job.
3.
Load the documents face up and trailing, as specified in the job. Place the address
carrier in feeder 1.
4.
Tap the [1x] button to start a test run or tap the [Start] button to start the job. If you
tap the [1x] button, the system helps you to adjust the address position (see
on page 20).
13
| Page 13 | Jan-15-2019 03:21 | Working with Jobs
3
English
