HARDWARE KIT
TOOLS REQUIRED
3M Double-sided Body Moulding Tape
None
- already applied to the deflector
1
– 3M Adhesive Promoter
Attention
: This product uses a 3M adhesive product that requires installation and curing temperatures of at least 20°C/ 70°F for 24
hours to develop maximum adhesion to the surface.
Failure to install this product at the proper temperature or allow adequate
curing time before use is not covered under warranty.
1. The deflectors mount to the window frames of the doors. Make sure that those areas are clean and dry.
2.
Start
with the Passenger’s side front door of the vehicle.
3.
To understand how the deflector will fit, place the front Passenger’s door deflector up to the vehicle. Align the start point of the
deflector with the start point of the door as shown below. The top edge of the deflector runs flush along the top edge of the window
frame.
4. Prime the contact area on the window frame with the adhesive promoter.
5. Beginning at the start point of front door deflector, peel only the first 30-40 cm (12-15 inches) of the protective backing from the tape
on the flange of the deflector. Press the deflector into place as determined above. Work forward, removing the protective backing
from the tape and pressing the part into place.
6. Once the deflector is in place press down
hard
along the entire flange area to make sure that the tape is fully adhered to the
vehicle.
7. Repeat steps 3-6 for the remaining deflectors. When installing the rear door deflectors, begin at the start point of the deflector and
work back.
Be sure
to allow a gap between the front and rear deflectors similar to the gap between the doors.
CARE INSTRUCTIONS
Clean the deflectors with a mild soap and water solution or plastic cleaner only.
Do not use chemicals or solvents
.
Periodically check to make sure the deflectors are secure.
Avoid using automatic car washes
.
ILLUSTRATION
– SIDE VIEW, ALIGNMENT
Thank you for purchasing Formfit side window visors.
Retain sheet for Care Instructions and Kit Information.
SD 13B07 Rev0.Jan 5, 2018
1/8
– 1/4” Gap to
Match Door Gap
Align and Start Point Here
3M Primer 94 Instructions
-Squeeze tube in middle to break inner ampule
-Apply to clean, dry surface
-Allow at least 5 minutes to dry before taping
Side Window Visors
Installation Instructions
SD 13B07
Nissan Sentra 2007-12
