FORM FIT
HOOD PROTECTOR
FORM FIT
HOOD PROTECTOR
Ford Expedition 2003 -
HDW 8A 03
Ford Expedition 2003 -
HDW 8A 03
Thank you for purchasing a
form fit
hood protector.
Thank you for purchasing a
form fit
hood protector.
Care Instructions
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure the bumpons are in place and the protector is secure.
Periodically check to make sure the bumpons are in place and the protector is secure.
Attention!
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Tools Required
Tools Required
#
2
#
2
Installation Instruction
Installation Instruction
Illustration #1 : Hardware Assembly
Illustration # 2 : Bumpon Placement
Illustration #1 : Hardware Assembly
Illustration # 2 : Bumpon Placement
x 2
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Insert the expansion plugs through the holes in the protector into the holes in the hood.
Be sure that the protector is well seated against the hood and then insert and tighten the
screws into the expansion plugs.
See Illustration # 1.
4. Insert the screws into the expansion plugs. Adjust the protector for best fit then, tighten
the screws into the expansion plugs
(do not over tighten)
.
See Illustration #1
5. Install the (2) two bumpons as shown in
Illustration #2
.
Attention: The bumpons must
be installed on the hood not the protector!!!!
If the bumpons are installed on the
protector, they will wear through the paint.
6. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for
proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
#10 x 5/8” Screws
x 4
Made in Canada Rev0.030320
x 4
Protector
Bumpons
x 2
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Insert the expansion plugs through the holes in the protector into the holes in the hood.
Be sure that the protector is well seated against the hood and then insert and tighten the
screws into the expansion plugs.
See Illustration # 1.
4. Insert the screws into the expansion plugs. Adjust the protector for best fit then, tighten
the screws into the expansion plugs
(do not over tighten)
.
See Illustration #1
5. Install the (2) two bumpons as shown in
Illustration #2
.
Attention: The bumpons must
be installed on the hood not the protector!!!!
If the bumpons are installed on the
protector, they will wear through the paint.
6. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for
proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
#10 x 5/8” Screws
x 4
x 4
Protector
Bumpons
Made in Canada Rev0.030320
