FORM FIT
HOOD PROTECTOR
Dodge Durango 2004 -
HDW 6G 04
Hardware
Kit
Tools Required
5 – Large Bumpons
1 – Phillips Screwdriver #1 & #2
4 – 3M Anti-abrasion Film Pads
4
–
Black
‘C’
Clips
4 – #6 x 3/8” Screws
4 – #4 x 3/16” Screws
Installation
1.
Be sure that the hood is clean and dry inside and out. Open the hood of the vehicle.
2. Install
one (1) bumpon on the center of leading edge of the hood as shown in
Illustration #1.
Attention: The bumpon must be installed on the hood, not
on the protector!!!.
If the bumpon is installed on the protector, it will wear through the paint.
3.
With protector centered on the hood, peel and fold an anti-abrasion film pad in half over the edge of the hood, underneath each of the two (2) inner holes in
the protector.
See Illustrations #2 & #3.
4.
Slide the “C” clips on the hood in line with the holes in the protector. Be sure that the “C” clips are well seated against the hood; it may be necessary to tap
on the clips.
See Illustrations #2 & #3.
5.
Be sure that the hole in the top of the clips lines up with the hole in the protector, then tighten the #6 x 3/8” screws, through the protector and into the top of
the “C” clips.
Do not over tighten
.
See Illustration #3.
6.
Make sure all the “C” clips are well seated against the hood. Tighten the #4 x 3/16’’ screws in the back of the “C” clips.
See Illustration #3.
7.
Repeat step #3, #4, #5 and #6 for the two (2) outside holes.
8.
Install four remaining bumpons as shown in
Illustration #1.
Attention: The bumpons must be installed on the hood, not on the protector!!!.
If the
bumpons are installed on the protector, they will wear through the paint.
9.
On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
Care Instruction
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents.
Periodically check to make
sure that the bumpons are in place and that the protector is secure.
Avoid using automatic car washes.
Do not pull on the protector when opening or
closing the hood.
Illustration
#1:
Bumpon
Location
Bumpons (Step #8)
Bumpon (Step #2)
Illustration #2: Clip Location
Illustration #3: Clip Configuration
Clips
Thank you for purchasing a
form fit
hood protector.
Retain this sheet for care instructions and kit information
Made in Canada
Rev0.040518
