FORM FIT
HOOD PROTECTOR
Chevrolet Heavy Duty Truck 2005-
HDW 5M 05
Chevrolet Heavy Duty Truck 2005-
HDW 5M 05
FORM FIT
HOOD PROTECTOR
Thank you for purchasing a
form fit
hood protector.
Thank you for purchasing a
form fit
hood protector.
Care Instructions
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure all the hardware is in place and the protector is secure.
Periodically check to make sure all the hardware is in place and the protector is secure.
Attention!
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Hardware Kit
Hardware Kit
Tools
Required
Tools
Required
#
2
#
2
Installation Instruction
Installation Instruction
Illustration: Hardware Assembly
Illustration: Hardware Assembly
x 5
Hood
Expansion Plug
Protector
Screw
Washer
Hood
Expansion Plug
Protector
Screw
Washer
x 5
x 5
x 5
# 10 x 5/8’’ Screws
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (
do not over tighten
).
See Illustration
below.
Note: Do not pull on the protector when opening or closing the hood.
Made in Canada Rev0.050131
x 5
x 5
# 10 x 5/8’’ Screws
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (
do not over tighten
).
See Illustration
below.
Note: Do not pull on the protector when opening or closing the hood.
Made in Canada Rev0.050131
