Section 7
CARE AND MAINTENANCE
WaterPur
TM
Operating Instructions (Cont’d)
The replaceable cartridge, which is the heart of the
WaterPur
TM
system, has been tested to meet the
material requirements of NSF Standards 42, 53 and 58. It has been tested to meet the performance
requirements of NSF Standard 42 for Class 1 Chlorine reduction and Standard 53 for Class 1 Turbidity
and Cyst reduction.
WaterPur
TM
Prior to using your Aviator’s fresh water system with the
WaterPur
TM
CCI-10CLW12 installed, the
entire system should be sanitized and rinsed. When sanitizing, make sure the
WaterPur
TM
filter cartridge
is not in the filter housing.
• Place one ounce of household bleach (such as Clorox) in your Aviator’s fresh water tank, for each ten
gallons of capacity. (If your tank holds 30 gallons, put 3 ounces of bleach in the tank.) Fill your
Aviator’s fresh water tank with potable water.
• SLOWLY open the faucets in your Aviator and allow water to flow until you smell chlorine at each
faucet, then close the faucet. DO NOT PERMIT THE CHLORINATED WATER TO SPLASH ONTO
CLOTHES, WALLS, COUNTERS OR FLOORS. Allow the system to sit overnight.
• Drain the fresh water tank and fill with potable water. Run the faucets until the chlorine smell is gone.
Repeat as necessary.
• Shut off the fresh water pump or disconnect from your city water supply. Open the kitchen faucets to
remove pressure. Place a shallow pan beneath the
WaterPur
TM
filter.
• Remove the sump from the
WaterPur
TM
housing by turning counterclockwise being careful not to spill
the water in the housing. Empty the water from the housing.
• Unwrap the
WaterPur
TM
cartridge and place it in the housing. (Either side up). Make certain that the
‘O’ ring is properly seated, and reattach the housing to the filter cap by turning clockwise. Tighten the
housing firmly by hand.
DO NOT
over tighten.
• Close the kitchen faucets and either turn on your fresh water pump or your city water supply. Check for
leaks at the filter housing. Tighten if necessary. Open the kitchen faucet and allow water to flow for ten
minutes. Your
WaterPur
TM
system is now ready to deliver fresh tasting filtered water to all of the
faucets in your Aviator!
WaterPur
TM
To winterize your Aviator’s water system, remove the
WaterPur
TM
cartridge from the housing and
follow manufacturer’s directions for dewinterizing, then replace the
WaterPur
TM
cartridge. The cartridge
should be replaced every 12 months or 10,000 gallons, whichever comes first.
An easy way to remember to do this is to replace the cartridge when you dewinterize in the spring.
Replace the
WaterPur
TM
cartridge only with a genuine
WaterPur
TM
cartridge available from your Forest
River Inc. dealer.
Page 96
Revised September 2012