Section 4
LIVING QUARTERS, LP and ELECTRICAL
DO NOT
bring or store LP gas cylinders, gasoline or other flammable liquids inside your
Aviator.A fire or explosion could result.
DO NOT
fill container(s) to more than 80% capacity. Overfilling the LP tanks can result
in uncontrolled gas flow which can result in an explosion or fire.
NEVER
use any other type of LP gas container than the one furnished with your RV.
If the tank must be replaced, check with your dealer for specifications.
LP gas regulators must always be installed with the regular vent facing downward.
Regulators that are not in compartments have been equipped with a protective cover. Be
sure the regulator cover is kept in place to minimize vent blockage that could result in
excessive gas pressure causing fire or explosion.
DO NOT
use butane or butane mixtures in your LP tank. When you fill your tanks be
sure to use propane only.
DO NOT
make repairs to the LP tank. The LP gas system is designed to meet rigid
standards. Except for simple maintenance and occasional tightening of a connection,
always take your Aviator to an authorized dealer for LP gas problems.
Always have an authorized LP gas supplier fill your LP tanks. When the LP gas container
is being filled,
DO NOT
smoke, strike a match or ignite a lighter. A spark or flame could
ignite fumes. Also be sure all burner and pilot flames are out and the service valve is
closed.
If you detect a sulfur or ‘rotten egg’ odor,
DO NOT
turn on any appliances. Shut off
all operating appliances. Extinguish any open flames, including cigarettes.
DO NOT
touch any electrical switches. Open windows and doors and exit your Aviator. Shut off the
gas supply at the LP tank (or source). Immediately call a Service Center or LP gas
supplier from an outside telephone and follow their instructions.
DO NOT
turn on the gas supply until the gas leaks have been repaired.
DO NOT
attempt to adjust or repair the regulator. Adjustments and repairs require
specialized training and tools. Contact a qualified LP Service Technician. Failure to
follow these instructions could result in fire or explosion.
DO NOT MODIFY YOUR LP SYSTEM. DO NOT REMOVE COMPONENTS OR REPLACE
WITH COMPONENTS THAT ARE NOT OF EQUAL SPECIFICATIONS.
Page 43
Revised September 2012