Document Information
Page 25 of 31
FSS JODY-W263 Integration Instructions Rev 02.docx
www.foresightsports.com
7.1.2 FCC Compliance statement
JODY-W263 module has modular approval and complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
⚠
Any changes or modifications NOT explicitly APPROVED could cause the JODY-W263 module
to cease to comply with FCC rules part 15 thus void the user's authority to operate the
equipment.
The internal / external antenna(s) used for this module must provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
In accordance with 47 CFR § 15.19, the end product into which this module is integrated shall
bear the following statement in a conspicuous location on the device:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.”
When the end-product is so small or for such use that it is not practical to place the above
statement on it, the information shall be placed in a prominent location in the instruction
manual or pamphlet supplied to the user or on the container in which the device is marketed.
However, the FCC ID label must be displayed on the device.
If the end-product will be installed in locations where the end-user is not able to see the FCC ID
and/or this statement, the FCC ID and the statement shall also be included in the end-product
manual.
☞
The outside of final products containing the JODY-W2 module must display in a user
accessible area a label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains Transmitter Module FCC ID:
2A6QA-JODYW263FSS
” or
“Contains FCC ID:
2A6QA-JODYW263FSS
”.
7.1.3 Canada (ISED)
JODY-W2 series module are certified for use in accordance with the Canada Innovation, Science
and Economic Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2
and RSSGen. Below is the list of the ISED IDs allocated to JODY-W263 module.
