Ford TOURNEO CONNECT, Руководство пользователя

Страница: 84 / 437

2. Touch the sensor
→
Fig. 55
B
on the
outside of the door handle. All direction
indicators flash once.
The unlock function is deactivated for
a few seconds so that you can check that
the vehicle has been locked properly.
Temporarily deactivating Keyless Entry
You can deactivate Keyless Entry tempora-
rily to prevent unauthorised third parties
from unlocking and starting the vehicle:
1. Lock the vehicle with the button in
the vehicle key.
2. Touch the sensor on the outside of the
door handle once within five seconds
→
Fig. 55
B
. Do not reach into the door
handle. Keyless Entry is deactivated
temporarily.
3. Check deactivation, wait ten seconds
and pull the door handle again. It
should not be possible to open the
door.
When the vehicle is next unlocked, it can be
unlocked only using the vehicle key. Keyless
Entry is reactivated the next time the vehi-
cle is unlocked.
Permanently deactivating Keyless En-
try
You can deactivate Keyless Entry perma-
nently in the Infotainment system to pre-
vent the vehicle from being unlocked and
started by unauthorised third parties.
Troubleshooting
Keyless Entry not working
The sensors may have limited functionality
if they become very dirty or icy.
1. Clean the sensors.
All direction indicators flash four times
The vehicle key used last is still in the vehi-
cle.
1. Remove the vehicle key and lock the
vehicle.
Automatic sensor switch-off
The sensors will be disabled in the follow-
ing circumstances:
— If the vehicle is not locked or unlocked for
an extended period.
— If a sensor is touched too many times.
Reactivating the sensors:
1. Unlock the vehicle with the button in
the vehicle key.
NOTICE
Please note that the sensors in the door
handles can be activated by a powerful jet
of water or steam if a valid vehicle key is si-
multaneously within its operating range. If
at least one window is open and sensor
surfaces on the door handles are continu-
ously activated, all windows will close. All
windows could open if the jet of water or
steam is
briefly moved away from the door
handle sensor surfaces and then moved
back onto them
→ page 81.
There may be a malfunction in the
Keyless Entry system if the message
Error. Keyless Entry system appears on the
instrument cluster display. Go to a qualified
workshop.
If there is no vehicle key in the vehicle
or if it is not detected, a message will
be shown on the instrument cluster display.
This may occur if the vehicle key is subject
to interference from another radio signal or
is covered by an object, e.g. an aluminium
case.
Doors and central locking but-
ton
Introduction
If the vehicle key or central locking fails, the
doors can be locked manually and, in some
cases, also unlocked manually.
The central locking system enables you to
centrally lock and unlock all the doors, the
boot lid and the tank
flap.
The vehicle can only be locked with the ve-
hicle key if the ignition has been switched
82 Opening and closing