Ford Ranger 2020, Руководство по монтажу, Страница: 71 / 94

5.1 Body
5.1.1 Body Structures - General
Information
WARNING: All external or internal
projections must comply with ECE
Regulations.
CAUTION: Load carrying structures
should not be mounted onto an existing
load tray or load box.
When carrying out vehicle
conversions/modifications the following points
should be considered:
•
Make sure that the vehicle structural integrity
is maintained.
•
Do not drill into closed frame body members.
•
Make sure that the design for the body
alterations or additional structure disperse the
load evenly.
CAUTION: Uneven load distribution could
result in unacceptable handling and
braking characteristics.
•
Re-paint metal edges after cutting or drilling.
All metal edges must comply with exterior and
interior protection legislation.
•
All fixings through the floor, sides or roof must
be sealed.
•
Make sure that fixings in the B-pillar area do
not encroach on the seat belts or seat belt
reels.
5.1.2 Integrated Bodies and
Conversions
WARNING: All wheel guard envelopes
must comply with ECE Regulations.
For integral structures such as ambulances or
motor-homes with increased rear overhang built
onto the chassis the following applies:
•
Reduced departure angles, e.g. rear entry step,
should be discussed with the end user /
customer. Consider removable components
to avoid damage on ferries or low-loaders.
•
Unique spare wheel stowage may be required
if obscured by rear step, check for accessibility.
•
The recommended dimensions for wheel
guards on conversions are outlined in the
following figure.
Date of Publication: 09/2020
FORD RANGER 2020
5 Body and P
aint
71