Ford Pro NL38-10C823-AA, Руководство по установке, Страница: 5 / 69

P a g e | 5
Installation Method Checklist
Installation Method Checklist
DO NOT DRILL ANY HOLES IN CHARGER UNTIL METHOD IS DETERMINED
1
Minimum 100 Amp Service Available for Standard 80 Amp Installation
If Customer does not have 100 Amp available, refer to Amp Setting Switch to adjust Charger
Amperage (Listed in Table of Contents)
2 Standard Mounting to Interior Stud Wall (Hardware Included)
3
Exterior Mounting to Non-Standard Wall (Concrete, Brick, Non-wood surfaces)
Non-Standard Mounting hardware not supplied
–
Alternate Hardware chosen must support
100 Lbs.
4
Mounting requiring watertight Glands (Conduit Mounting Hardware not supplied).
Rigid Conduit is preferred installation method.
5
AC Rear Inlet Wiring Method (Standard
–
Mounting Hole supplied in Charger)
NOTE: Remove Rear Plug prior to attaching Charger to Mounting Bracket if this method is
chosen
6
AC Left Inlet Wiring Method (Alternate
–
Requires Drilling for 1
”
Trade Size Conduit)
1” Meyers Hub
(Type 4 or 4X) requires 1-3/8
” Hole (Follow Hub manufacturer’s instructions)
Conduit Mounting Hardware not supplied
7
AC Right Inlet Wiring Method (Alternate
–
Requires Drilling for 1
”
Trade Size Conduit)
1” Meyers Hub
(Type 4 or 4X) requires 1-3/8
” Hole (Follow Hub manufacturer’s instructions)
Conduit Mounting Hardware not supplied
8
HVDC Inverter
(If customer has Inverter
–
Requires Drilling for
¾”
Trade Size Conduit either Left or Right)
¾” Meyers Hub
(Type 4 or 4X) requires 1-
1/8” Hole (Follow Hub manufacturer’s instructions)
Conduit Mounting Hardware not supplied
9 HVDC Inverter Inlet Left Wiring Method
10 HVDC Inverter Inlet Right Wiring Method