2. Install a new oil filter element.
3. Install the oil filter housing. Torque to
16–19 lb.ft (22–26 Nm) using a torque
wrench.
Note:
Use only a Motorcraft FL-2087 oil
filter for maximum performance, reliability
and durability.
Note:
The use of any oil filter other than the
dealer supplied oil filter may cause engine
damage.
See the Engine Oil Check section in the
Maintenance chapter of your Owner's
Manual for information on checking the
engine oil.
ENGINE COOLANT CHECK
The concentration and level of engine
coolant should be checked at the mileage
intervals listed in the scheduled
maintenance information.
Note:
Make sure that the level is between
the
MIN
and
MAX
marks on the engine and
coolant reservoirs.
Note:
Coolant expands when it is hot. The
level may extend beyond the
MAX
mark. If
the level is at the
MIN
mark, add coolant
immediately.
The coolant concentration should be
maintained within 48% to 50%, which
equates to a freeze point between -30°F
(-34°C) and -34°F (-37°C).
Note:
For best results, coolant
concentration should be tested with a
refractometer such as Rotunda tool
300-ROB75240 available from your dealer.
We do not recommend the use of
hydrometers or coolant test strips for
measuring coolant concentrations.
Be sure to read and understand
Precautions in your Owner’s Manual. If the
coolant has not been checked at the
recommended interval, the engine coolant
reservoir may become low or empty. If the
reservoir is low or empty, add coolant to
the reservoir. See Adding Engine Coolant
in this chapter.
Note:
Automotive fluids are not
interchangeable. Do not use engine coolant,
antifreeze or windshield washer fluid outside
of its specified function and vehicle
location. For more information about engine
coolant, see the Maintenance chapter of the
Owner’s Manual.
Adding Engine Coolant
WARNING:
Do not add engine
coolant when the engine is on or the
cooling system is hot. Failure to follow
this instruction could result in personal
injury.
WARNING:
Do not put coolant in
the windshield washer reservoir. If
sprayed on the windshield, coolant could
make it difficult to see through the
windshield.
WARNING:
To reduce the risk of
personal injury, make sure the engine is
cool before unscrewing the coolant
pressure relief cap. The cooling system
is under pressure. Steam and hot liquid
can come out forcefully when you loosen
the cap slightly.
WARNING:
Do not add coolant
further than the
MAX
mark.
41
Mustang (CZG) GT500, United States of America, Vehicles With: SVT Performance Package, enUSA, First-Printing
Maintenance
Содержание Mustang Shelby GT500 2020
Страница 3: ......
