Erasing HomeLink
T
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
t
buttons until the red
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
t
is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the
“Programming”
section.
Reprogramming a single HomeLink
T
button
To program a device to HomeLink
t
using a HomeLink
t
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
t
button.
Do NOT
release the
button.
2. The red indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
t
button, follow step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
t
at
www.homelink.com
or
1–800–355–3515.
MESSAGE CENTER
With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems.
You may select
display features on the message center for a display of status preceded
by a brief indicator chime. The system will also notify you of potential
vehicle problems with a display of system warnings followed by a long
indicator chime.
Driver Controls
118
