Ford FWL-1003, Инструкция по эксплуатации

Страница: 4 / 6

FWL-1003 EN
Copyright © 2015 P á g i n a
| 3
www.Ford-tools.com
Do not abuse the cord.
ƒ
Never use the cord for carrying, pulling or unplugging the power tool.
ƒ
Keep cord away from heat, oil, sharp edges or moving parts.
ƒ
Damaged or entangled cords increase the risk of electric shock.
WARNING: Always check that the power supply correspond to the voltage
on the rating plate.
3.2 SPECIFIC SAFETY INSTRUCTIONS FOR LED FLASH LIGHTS
ƒ
Never attempt to open the LED Light unit for any reason. No user serviceable
parts inside. Do not attempt to replace or change the LED lights.
ƒ
If the protective glass is cracked or broken, it must be replaced by a qualified
service facility.
ƒ
Inspect the flashlight before each use.
WARNING: Do not stare directly at the light beam. It could cause damage to
the eyes.
4 WARNING
ƒ
Never attempt to change wire connection way as this has been fixed
professionally.
ƒ
The lighting fixture shall be fixed on stand vertically that the longitudinal axis
does not slant than ±4°from the ground plate.
ƒ
Disconnect the plug (all-poles) from the network when the front glass is open,
and follow the instructions to the next step
ƒ
Replace before using the shielding glass if it is damaged.
ƒ
If the external flexible cable or cord of this luminary is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
5 ASSEMBLING LAMP ON TRIPOD (FIG. 1)
ƒ
First loosen the wing-nut screw on the tripod (A) and flex the tripod legs. Make
sure the tripod stands stable and retighten the wing-nut.
ƒ
Now twist pole screws(B) left to open and extend to your required height. twist
right to lock the pole so it doesn’t slide down.
ƒ
Loosen the quick release mechanism(C) and set up the lamp on the top of the
pole. Lock the lamp in place with the quick release mechanism (C).
6 ASSEMBLING THE FLOODLIGHT ONTO THE STAND
(FIG. 1)
ƒ
First unscrew the black wing-nut (F).
ƒ
Put the lamp on the H-shaped base (E) in such a way so that the two slots
align. Put the wing screw through both slots and tighten the nut.
ƒ
By loosening the wing screws (D) on both sides of the lamp you can put the
lamp into the desired angle.
ƒ
Lock the lamp in place by tightening the wing screws.