If the fuse is not blown and the brake lamps are working properly, the
following procedure will allow you to move the gearshift lever from P
(Park):
1. Apply the parking brake, turn the
ignition key to the off position, and
remove the key.
2. Using a screwdriver (or similar
tool), carefully pry off and remove
the chrome trim ring (1) from the
shifter base.
3. Open the storage compartment
lid and carefully pry the trim panel
(2) up from rear attachments on the
storage compartment and disconnect it from the console to expose the
inside of the gearshift.
4. Locate the brake-shift interlock
lever on the driver’s side of the
shifter assembly.
5. Apply the brake pedal. Using a
screwdriver (or similar tool), press
and hold the brake-shift interlock
lever while pulling the gearshift
lever out of the P (Park) position
and into the N (Neutral) position.
6. Install the trim panel (2) and
chrome ring (1) in reverse order.
7. Apply brake pedal, start the vehicle, and release the parking brake.
See your authorized dealer as soon as possible if this procedure
is used.
WARNING:
Do not drive your vehicle until you verify that the
brake lamps are working.
WARNING:
Always set the parking brake fully and make sure
the gearshift is latched in P (Park). Turn the ignition to the off
position and remove the key whenever you leave your vehicle.
1
2
Driving
222
2011 Fusion
(fsn)
Owners Guide, 3rd Printing
USA
(fus)
Содержание Fusion 2011
Страница 295: ... 3 0L V6 engine 3 5L V6 engine Maintenance and Specifications 295 2011 Fusion fsn Owners Guide 3rd Printing USA fus ...
Страница 346: ...Ford Extended Service Plan 346 2011 Fusion fsn Owners Guide 3rd Printing USA fus ...
Страница 353: ...Scheduled Maintenance 353 2011 Fusion fsn Owners Guide 3rd Printing USA fus ...