Ford EVEREST 2009, Руководство пользователя

Страница: 126 / 286

Black plate (126,1)
CAUTION
Do not run the engine if the oil pressure
is low. It could result in extensive
engine damage.
q
Check Engine Light
í
This indicator light illuminates when the
ignition switch is turned to the ON
position and goes off when the engine is
started.
If this light comes on while driving, the
vehicle may have a problem. It is
important to note the driving conditions
when the light came on and consult an
expert repairer, we recommend an
Authorised Ford Repairer.
The check engine light may come on in
the following cases:
l
The engine's electrical system has a
problem.
l
The emission control system has a
problem.
If the check engine light remains on, do
not drive at high speeds and consult an
expert repairer, we recommend an
Authorised Ford Repairer as soon as
possible.
If the low fuel warning and check
engine lights illuminate at the same
time (3.0L TDCi and 2.5L TDCi)
The check engine light may illuminate if
air enters the fuel lines such as when the
fuel tank is nearly empty.
Bleed the air from the fuel lines using the
following procedure to turn off the light.
1. Refuel until the low fuel warning light
turns off (about 10 liters or more).
2. Pump the priming pump on the upper
part of the fuel filter to bleed out the
air.
Refer to Running Out of Fuel on page
7-19.
3. Start the engine and continue driving
for about 10 seconds while the engine
is idling normally.
4. Turn off the engine and wait about 10
seconds.
5. The check engine light turns off when
the engine is started after repeating
Steps 3 and 4 three times.
6. If the light remains illuminated, repeat
Steps 2 to 5 again.
If the check engine light remains
illuminated even after performing the
above procedure, consult an expert
repairer, we recommend an Authorised
Ford Repairer.
5-36
Driving Your Ford
í
Some models.
Warning/Indicator Lights and Beep Sounds
EVEREST_F8M7-10-09B_Edition1 Page126
Tuesday, February 10 2009 12:54 AM
Form No.F8M7-10-09B