12
13
*
if equipped
Ambient Lighting
*
Light your vehicle interior with a choice of several
colors with the ambient lighting feature. You can
access this feature through the
Settings
menu
for SYNC 3.
Tap a color to switch on ambient lighting to set a
color. Drag the colors up and down to increase or
decrease the intensity.
To switch ambient lighting off, press the active color
once or drag the active color all the way down to
zero intensity.
The ambient lighting turns on when you switch on
the ignition and the headlamps. Your vehicle interior
remains lit until you switch off the ignition and either
lock your vehicle or allow the accessory delay timer
to expire.
Heated Front Seats
*
The front heated seat controls are
on the center console near the
gearshift lever. Adjust the control
to your desired heat setting.
Remote Start
*
Remote start allows you to start
the engine from outside your
vehicle using your transmitter.
To start, press and then press
twice within a few seconds.
When inside, apply the brake while
pressing the
START STOP
button.
Shift into drive (D) and go. To
switch off the engine from outside
the vehicle after using your remote
start, press
once.
Rear Reclining Seats
Pull the lever up to recline the seatback to the
desired position. Pull the lever up to fold the seatback
forward. You may need to fold the outboard head
restraints and lower the center head restraint first.
Moonroof and Sunscreen
*
The moonroof and sunscreen have a one-touch open and
close feature. To stop them during a one-touch operation,
press the control a second time.
Press and release the rear of the control to open the
sunscreen. Press and release the front of the control to
close the sunscreen.
Note:
If the moonroof is open, it closes automatically before
the sunscreen.
Press and release the rear of the control to open the
moonroof. The moonroof stops short of the fully opened
position. Press and hold the control again to open the
moonroof fully. Press and release the front of the control to
close the moonroof.
Memory Function
*
Use this feature to program and recall
the positions of the driver seat and
power mirrors. The controls are on
the driver door. To program position
1
,
switch on the ignition, and press and
hold the
1
button until you hear a tone.
Use this same procedure to set positions
2
and
3
using
the respective buttons. You can now use these controls to
recall the set memory positions.
See the
Seats
chapter in your
Owner’s Manual
for details.
Tilting Front-row Head Restraints
Tilt the head restraint
forward for additional
comfort by gently pulling
the top of the head
restraint. Once it is in the
forward-most position,
tilting it forward again
releases it to the
upright position.
Note:
Do not attempt to
force the head restraint
backward after you tilt it.
Comfort
