Ford BRONCO 2023, Краткое руководство пользователя

Страница: 24 / 30

REMOVABLE VEHICLE COMPONENTS
INSTALLING THE DOORS
1. Switch the ignition off.
2. Fold the mirrors completely forward
before installing the front doors.
3. Inspect and clean debris from the
bodyside and door hinges.
4. If you are using a storage bag, unzip it far
enough to allow access to the hinges.
5. Locate the fender and door protectors in
the tool pouch. Install one over the fender
edge near the upper door hinge and the
other on the door edge near the bottom
door hinge.
6. Locate the lower bodyside hinge and
loosely install the alignment pin by hand.
7. Locate the upper door hinge portion and
the upper bodyside hinge.
8. With the help of another person, lower
the door onto the body hinges, aligning
the upper door portion to the upper body
pin and the lower door portion to the
alignment pin. Make sure you do not
pinch the wiring connector harness
between the door and the body of
the vehicle.
9. Remove the lower alignment pin.
10. Hand start the hinge bolts to the upper
and lower door hinges.
11. Use the hex tool to tighten the bolts.
We recommend that you use a torque
wrench to make sure you tighten
the bolts to 22 lb.ft (30 Nm).
12. If using a storage bag, remove it from
the door.
13. Open the harness connector door
and insert the door harness into
the connector.
14. Open and close the installed door a few
times to make sure it is aligned properly
and operates normally.
15. To install additional doors repeat
Steps 3 - 14.
16. Close the doors and switch the ignition
on. Check for any warning messages.
17. Return mirrors to the driving position.
REMOVABLE FENDERS
To remove the fender flares:
1. Unlock the five quarter turn clips by
turning them counterclockwise.
2. Pull outward on the fender flare with
both hands to unseat the five pushpins
from the sheet metal.
Note: The pushpins and quarter pins should
not be removed from fender flare.
To install the fender flares:
1. Press five pushpins in until they
are seated.
2. Lock the five quarter turn clips by turning
the clips clockwise.