Ford 2016 FIESTA ST, Инструкция к добавке

Страница: 26 / 33

4. Turn the hazard flashers on then off
three times. You must accomplish this
within 10 seconds. If you have entered
the reset mode successfully, the horn
will sound once, the system indicator
will flash and a message appears in the
information display. If this does not
occur, please try again starting at Step
2. If after repeated attempts to enter
the reset mode, the horn does not
sound, the system indicator does not
flash and no message is shown in the
information display, seek service from
your authorized dealer.
5. Train the tire pressure monitoring
system sensors in the tires using the
following system reset sequence. Start
with the left front tire in the following
clockwise order: left front (driver's side
front tire), right front (passenger's side
front tire), right rear (passenger's side
rear tire), and left rear (driver's side rear
tire).
6. Remove the valve cap from the valve
stem on the left front tire. Decrease the
air pressure until the horn sounds.
Note: The horn will sound once when
the module learns the sensor
identification code for this position. If
you hear the horn sound twice, the
reset procedure was unsuccessful, and
you must repeat the entire procedure.
7. Remove the valve cap from the valve
stem on the right front tire. Decrease
the air pressure until the horn sounds.
8. Remove the valve cap from the valve
stem on the right rear tire. Decrease the
air pressure until the horn sounds.
9. Remove the valve cap from the valve
stem on the left rear tire. Decrease the
air pressure until the horn sounds.
Training is complete after the horn
sounds for the last tire trained (driver's
side rear tire), the system indicator
stops flashing, and a message is shown
in the information display.
10. Turn the ignition off. If you hear the
horn sound twice, the reset procedure
was unsuccessful and you must
repeat it. If after repeating the
procedure and you hear the horn
sound twice when you turn the
ignition off, seek assistance from your
authorized dealer.
11. Set all four tires to the recommended
air pressure as indicated on the
Safety Compliance Certification
Label (affixed to either the door hinge
pillar, door-latch post, or the door
edge that meets the door-latch post,
next to the driver's seating position)
or Tire Label located on the B-Pillar
or the edge of the driver's door.
CHANGING A ROAD WHEEL
See the Wheels and Tires chapter of your
owner's manual for instructions on
changing a road wheel.
Full Size Spare
Your ST vehicle is equipped with a full-size,
spare tire assembly. Although the spare is
a traditional, full size tire (as opposed to a
mini-spare), it is different in both size and
handling characteristics from the standard
Fiesta ST performance tire. If you need to
install the spare tire, you must adhere to
the following precautions:
• Because of the different performance
characteristics of the spare tire, avoid
aggressive steering, braking,
acceleration or high speeds when the
spare tire is installed.
• Never enable electronic stability
control sport mode or fully disable
electronic stability control when the
spare tire is installed.
• Replace the spare tire with the correct
original equipment specified tire as
soon as possible.
23
Fiesta (CCT) Canada/United States of America, enUSA, First Printing
Wheels and Tires