Anti-Scan Feature
The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity
•
pressing the unlock button on the remote control
•
switching the ignition on
•
unlocking the vehicle using intelligent access.
Unlocking and Locking the Doors
To unlock the driver door:
Enter the factory-set 5-digit code or your
personal code. You must press each number within five seconds of each
other. The interior lamps will illuminate.
Note:
All doors will unlock if
the two-stage unlocking feature is disabled. Refer to
Locking and
Unlocking
earlier in this chapter.
To unlock all doors:
Enter the factory-set code or your personal code,
then press
3
•
4
within five seconds.
To lock all doors:
Press and hold
7
•
8
and
9
•
0
at the same time with
the driver door closed. You do not need to enter the keypad code first.
Displaying the Factory-Set Code with Integrated Keyhead
Transmitters
Note:
You will need to have two programmed Integrated Keyhead
Transmitters for this procedure.
To display the factory-set code in the information display:
1. Place the first programmed key in the ignition.
2. Turn the ignition off and remove the first programmed key.
3. Place the second programmed key in the ignition.
74
Locks
2014 Taurus
Owners Guide gf, 2nd Printing, September 2013
USA
(fus)