Ford 2014 FUSION ENERGI, Руководство пользователя

Страница: 258 / 478

7. Remove the three front bumper cover
lower fasteners, only on the side of the
headlamp you are servicing.
E159697
8. Separate the front bumper cover from
the fender and pull the fender outward
1.2 inches (3 centimeters).
E159698
9. From the front of the vehicle, pull the
front bumper cover forward 4 inches
(10 centimeters).
E159699
10. Carefully pull the headlamp assembly
outward to disengage it from the
lower fixing point.
11. Carefully lift the headlamp and
remove it from the vehicle.
12. Disconnect the electrical connector.
CHANGING A BULB
Lamp Assembly Condensation
Exterior lamps are vented to
accommodate normal changes in pressure.
Condensation can be a natural by-product
of this design. When moist air enters the
lamp assembly through the vents, there is
a possibility that condensation can occur
when the temperature is cold. When
normal condensation occurs, a thin film of
mist can form on the interior of the lens.
The thin mist eventually clears and exits
through the vents during normal operation.
Clearing time may take as long as 48 hours
under dry weather conditions.
Examples of acceptable condensation are:
•
Presence of thin mist (no streaks, drip
marks or droplets).
• Fine mist covers less than 50% of the
lens.
Examples of unacceptable moisture
(usually caused by a lamp water leak) are:
•
Water puddle inside the lamp.
• Large water droplets, drip marks or
streaks present on the interior of the
lens.
Take your vehicle to an authorized dealer
for service if any of the above conditions
of unacceptable moisture are present.
255
Fusion/Mondeo (CC7)
Maintenance