BULB REPLACEMENT
Lamp assembly condensation
Exterior lamps are vented to accommodate normal changes in pressure.
Condensation can be a natural by-product of this design. When moist air
enters the lamp assembly through the vents, there is a possibility that
condensation can occur when the temperature is cold. When normal
condensation occurs, a thin film of mist can form on the interior of the
lens. The thin mist eventually clears and exits through the vents during
normal operation. Clearing time may take as long as 48 hours under dry
weather conditions.
Examples of acceptable condensation are:
•
Presence of thin mist (no streaks, drip marks or droplets)
•
Fine mist covers less than 50% of the lens
Examples of unacceptable moisture (usually caused by a lamp water
leak) are:
•
Water puddle inside the lamp
•
Large water droplets, drip marks or streaks present on the interior of
the lens
Take your vehicle to dealer for service if any of the above conditions of
unacceptable moisture are present.
Using the right bulbs
Replacement bulbs are specified in the chart below. Headlamp bulbs
must be marked with an authorized “D.O.T.” for North America to ensure
lamp performance, light brightness and pattern and safe visibility. The
correct bulbs will not damage the lamp assembly or void the lamp
assembly warranty and will provide quality bulb burn time.
Function
Number of bulbs
Trade number
Headlamps (low and
high-beam)
2
*See your dealer
Front park lamps
2
3157K or 4157K
Front turn lamps
2
3157A (amber)
Front sidemarker
2
168A (amber)
Fog lamps
2
H11
Front row map lamps
2
1600XB
Lights
92
2010 Navigator
(nav)
Owners Guide
(own2002)
, 1st Printing
USA
(fus)
