Autounlock feature
The autounlock feature will unlock all the doors when:
•
the ignition is on, all the doors are closed, and the vehicle has been in
motion at a speed greater than 12 mph (20 km/h);
•
the vehicle has then come to a stop and the ignition is turned off or to
accessory; and
•
the driver door is opened within 10 minutes of the ignition being
turned off or to accessory.
Note:
The doors will not autounlock if the vehicle has been
electronically locked before the driver door is opened.
Deactivating/activating autounlock feature
Your vehicle comes with the autounlock features disabled; there are
three methods to enable/disable this feature:
•
Through your authorized dealer, or
•
by using a power door unlock/lock sequence, or
•
by using the instrument cluster message center (if equipped). Refer to
Message center
in the
Instrument Cluster
chapter.
Note:
The autounlock feature can be activated/deactivated
independently of the autolock feature.
Power door lock switch autounlock enable/disable procedure
Before starting, ensure the ignition is off and all vehicle doors are closed.
You must complete Steps 1–5 within 30 seconds or the procedure will
have to be repeated. If the procedure needs to be repeated, wait a
minimum of 30 seconds before beginning again.
1. Turn the ignition on.
2. Press the power door unlock
control on the door panel three
times.
3. Turn the ignition off.
4. Press the power door unlock
control on the door panel three
times.
5. Turn the ignition back on. The horn will chirp one time to confirm
programming mode has been entered and is active.
Locks and Security
74
2010 Econoline
(eco)
Owners Guide, 1st Printing
USA
(fus)