Conversely, a horn chirp followed by a honk will indicate the system is
enabled. Pressing the
control then the
control will turn the
feature ON if it was previously OFF, or OFF if it was previously ON. The
horn will chirp once if autolock was deactivated or twice (one short
chirp and one long honk) if autolock was activated.
5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Note:
After exiting the driver configuration mode, the horn will chirp
once to indicate a feature has been activated/deactivated.
Keyless entry key pad procedure
1. Turn the ignition to the 1 (OFF/LOCK) position.
2. Close all the doors.
3. Enter 5–digit entry code
4. Press and hold the 7
•
8. While holding the 7
•
8 press the 3
•
4.
5. Release the 3
•
4.
6. Release the 7
•
8.
The user should receive a
horn chirp
to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
Message center procedure
For information regarding the activation and deactivation of the
autolocks feature using the message center, refer to
Message center
in
the
Driver Controls
chapter.
CHILDPROOF DOOR LOCKS (ON VEHICLES WITH REAR DOORS)
•
When these locks are set, the
rear doors cannot be opened from
the inside.
•
The rear doors can be opened
from the outside when the doors
are unlocked.
The childproof locks are located on
rear edge of each rear door and
must be set separately for each
door. Setting the lock for one door
will not automatically set the lock for both doors.
•
Move lock control up to engage the childproof lock.
•
Move control down to disengage childproof locks.
2008 F-150
(f12)
Owners Guide (post-2002-fmt)
USA
(fus)
Locks and Security
146
