Locking the doors
1. Press
and release to lock all the doors. The lamps will flash.
Note:
If any door is not closed properly, the lamps will not flash until all doors
are closed.
2. Press
and release again within three seconds to confirm that all the
doors are closed and locked.
Note:
The doors will lock again and the
horn will make two quick chirps and the lamps will not flash until all the
doors are closed.
Note:
If any door is not closed properly, the horn will make two quick
chirps.
Sounding a panic alarm
Press
to activate the alarm. The horn will sound and the parklamps
will flash for a maximum of 3 minutes. Press again or turn the ignition to
the 3 (ON) position to deactivate, or wait for the alarm to timeout in
3 minutes.
Note:
The panic alarm will only operate when the ignition is in the
1 (OFF/LOCK) position .
Replacing the battery
The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.
To replace the battery:
1. Twist a thin coin between the two
halves of the remote entry
transmitter near the key ring. DO
NOT TAKE THE RUBBER COVER
AND CIRCUIT BOARD OFF THE
FRONT HOUSING OF THE
REMOTE ENTRY TRANSMITTER.
2007 07+ Explorer Sport Trac
(esp)
Owners Guide (post-2002-fmt)
USA
(fus)
Locks and Security
142
