Ford 2006 Escape Hybrid, Руководство пользователя

Страница: 140 / 328

Read Steps 1 - 4 thoroughly before proceeding with the
deactivation/activation programming procedure.
The driver and front passenger BeltMinder
娂
features can be
deactivated/activated by performing the following procedure:
Before following the procedure, make sure that:
•
The parking brake is set
•
The gearshift is in P (Park)
•
The ignition switch is in the OFF position
•
The driver and front passenger safety belts are unbuckled
To reduce the risk of injury, do not deactivate/activate the Belt
Minder feature while driving the vehicle.
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
•
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, at a moderate speed, buckle
then unbuckle the safety belt 9 times, ending in the unbuckled state.
(Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.)
•
After Step 3, the restraint system warning light (airbag light) will be
turned on for three seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
•
This will disable the BeltMinder
娂
feature for that seating position if it
is currently enabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds.
•
This will enable the BeltMinder
娂
feature for that seating position if it
is currently disabled. As confirmation, the restraint system warning
light will flash 4 times per second for 3 seconds, followed by 3
seconds with the light off, then followed by the restraint system
warning light flashing 4 times per second for 3 seconds again.
•
After receiving confirmation, the deactivation/activation procedure is
complete.
2006 Escape Hybrid (hev)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
140