•
Continue to press and hold the HomeLink
威
button (note Step 3 in the
“Programming” section) while you press and release —
every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
威
. The indicator light will
flash slowly and then rapidly after HomeLink
威
accepts the radio
frequency signal.
•
Proceed with Step 4 in the “Programming” section.
Operating the HomeLink
姞
Wireless Control System
To operate, simply press and release
the appropriate HomeLink
威
button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
Erasing HomeLink
姞
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
威
buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
威
is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the
“Programming”
section.
Reprogramming a single HomeLink
姞
button
To program a device to HomeLink
威
using a HomeLink
威
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
威
button.
Do NOT
release the
button.
REVIEW COPY
2005 Aviator f/k/a Navigator LS
(231)
, Owners Guide (post-2002-fmt)
(own2002)
,
Market:
USA_English
(fus)
Driver Controls
140
Содержание 2005 Aviator a Navigator LS
Страница 368: ...368...