PINPOINT TEST A: NO COMMUNICATION WITH THE MESSAGE CENTER MODULE (MCM)
PINPOINT TEST B: THE COMPASS IS INOPERATIVE
CONDITIONS
DETAILS/RESULTS/ACTIONS
A1
CHECK THE INSTRUMENT CLUSTER VOLTAGE SUPPLY
Instrument Cluster
Using the following table, measure the voltage between the instrument cluster pins, harness side and ground.
IC Connector Pin
Circuit
C239
11 1001 (WH/YE)
C240
7
295 (LB/PK)
C240
8
1112 (WH/LB)
Is the voltage reading greater than 10 volts?
Yes
GO to
A2
.
No
REPAIR the circuit(s) in question. TEST the system for normal operation.
A2
CHECK THE INSTRUMENT CLUSTER GROUND — CIRCUIT 1205 (BK)
Measure the resistance between the instrument cluster C240 pin 12, circuit 1205 (BK), harness side and ground.
Is the resistance less than 5 ohms?
Yes
REFER to
Section 418-00
.
No
REPAIR the circuit. TEST the system for normal operation.
CONDITIONS
DETAILS/RESULTS/ACTIONS
B1
RETRIEVE THE RECORDED DTCS FROM BOTH CONTINUOUS AND ON-DEMAND SELF-TESTS — MESSAGE CENTER MODULE (MCM)
Use the recorded message center DTCs from the continuous and on-demand self-test.
Are any message center DTCs recorded?
Yes
If MCM DTC U2013, GO to
B2
.
No
GO to
B5
.
B2
CHECK CIRCUIT 640 (RD/YE) FOR BATTERY VOLTAGE
Page 5 of 12
2001 Windstar Workshop Manual
11/30/2009
http://www.fordtechservice.dealerconnection.com/pubs/content/...
