Programming
Do not program the HomeLink
t
Universal Transceiver with the
vehicle parked in the garage.
1. Prepare for programming the
HomeLink
t
Universal Transceiver by
erasing the three factory default
codes by holding down the two
outside buttons until the red light
begins to flash after 20 seconds.
Release both buttons.
2. Hold the end of your hand-held
transmitter 5–14 cm (2–5 inches)
away from the HomeLink
t
Universal
Transceiver surface (located on your visor) while keeping the red light in
view.
3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLink
t
button. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with the procedure in the “Canadian Programing” section.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly.
5. Follow steps 2 through 4 to program the remaining two buttons.
If you do not successfully program the HomeLink
t
Universal Transceiver
after repeated attempts, refer to
Rolling code programing
which
follows, or call toll-free customer assistance: 1–800–355–3515 or on the
Internet at
HomeLink.jci.com.
Controls and features
80
