Ford 1996 Mustang, Руководство пользователя

Страница: 252 / 332

258
[SV21200(MBC )03/93]
❑
Start and idle engine until the radiator upper
hose is warm (this indicates the thermostat is
open and coolant is flowing through the
entire system).
[SV21300(MBC )03/93]
❑
Immediately shut off engine. Cover cap
completely with a thick cloth and cautiously
remove radiator pressure cap and add a
50/50 mixture of recommended coolant and
water until system is full.
[SV21400(MBC )03/91]
❑
Reinstall the radiator cap securely.
[SV21500(MBC )05/94]
❑
Remove the cap from the engine coolant
recovery reservoir and add a 50/50 mixture
of recommended cooling system fluid and
water to the FULL-HOT mark on the engine
coolant recovery reservoir. Check that
reservoir hose is not kinked.
[SV21800(MBC )03/93]
❑
Reinstall the reservoir cap.
*
[SV21900(MBC )05/95]
❑
Check for leaks at the draincock, block plug
and vent plug.
*
[SV22000(MBC )03/95]
❑
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use.
[SV22012(M )05/95]
4.6L (2V) engine only — GT models
*
[SV22014( ALL)03/95]
❑
With the engine OFF and cool, remove the
pressure cap, located on the coolant reservoir.
Remove the heater hose and clamp, located
on the rear of the intake manifold.
*
[SV22021( ALL)03/95]
❑
Add a 50/50 mixture of specified coolant and
water to the coolant reservoir. Refer to Refill
Capacities later in this chapter for the correct
amount. Add coolant to the reservoir until
the coolant continuously flows out of the tube
in the rear of engine. Reattach hose and
secure clamp.
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996