Force SPARC/CPCI-520G, Техническое справочное руководство

Страница: 48 / 134

Front Panel and Connectors Base-520(G) Installation
Page 34 SPARC/CPCI-52x(G)
4.5.4 Serial I/O Interface Connector Pinout
Both serial I/O interfaces of the Base-520(G) are independent full-duplex
channels. For each of them the 4 signals RXD, TXD, RTS, and CTS are
also provided via the respective CompactPCI J5 connector (for interface
A and B see figure 13 “CompactPCI J5 connector pinout” on page 36).
SERIAL A+B on the Base-520(G)’s front panel holds the signals for the
2 serial interfaces A and B.
SERIAL A+B on the Base-520(G)’s front panel holds the signals for the
2 serial interfaces A and B.
Table 17 26-pin serial A+B connector pinout RS232
Signal Pin Connector Pin Signal
n.c. 1 14 TxD_B (Output)
TxD_A (Output) 2 15 RxC_A (Input)
RxD_A (Input) 3 16 RxD_B (Input)
RTS_A (Output) 4 17 RTxC_A (Input)
CTS_A (Input) 5 18 RxC_B (Input)
DSR_A (Input) 6 19 RTS_B (Output)
GND_A (Ground) 7 20 DTR_A (Output)
DCD_A (Input) 8 21 DSR_B (Input)
n.c. 9 22 RTxC_B (Input)
n.c. 10 23 GND_B (Ground)
DTR_B (Output) 11 24 TxC_A (Output)
DCD_B (Input) 12 25 TxC_B (Output)
CTS_B (Input) 13 26 n.c.
14
1
26
13