Force S4810P, Установка, Страница: 23 / 49

Installing the S4810 System 23
Remove the SFP+ and QSFP+ optics
Remove an optic by pushing the tab on the optic and sliding the optic from the port.
When removing optics with Direct Attach Cables (DACs), pull the release tab firmly and steadily to
remove the optic from the port. You may need to gently push the optic into the port to ensure it is seated
properly, prior to pulling the tab.
Do not jerk or tug repeatedly on the tab.
Connect stacking ports (optional)
Rack-mount the chassis or insert them into a cabinet before you make your stacking port connections.
Insert one end of the optical cable into a configured port, and insert the other end into a similarly
configured port of the adjacent chassis.
There are no unique stacking ports; the SFP and QSFP+ ports can be configured to act stacking ports. The
SFP ports are labeled 0-47 and the QSFP+ ports are labeled 48 and 56 (lower ports) and 52 and 60 (upper
ports).
FTOS 8.3.7.1 supports stacking connections for up to 3 S4810 switches, to configure as a unified system.
Important Points
Keep the following in mind when stacking the S4810.
• Data ports are configured as stacking ports in predefined stacking groups of 40G (four 10G ports or
one 40G port).
• When a stack-group number is assigned, the ports associated with that group are configured as
stacking ports (
Figure 3 ):
• stack-group 0 = ports 0-3, stack-group 1 = ports 4-7, stack-group 2 = ports 8-11, and so on
through stack-group 11 = ports 44-47.
• stack-group 12 = port 48, stack-group 13 = port 52, stack-group 14 = port 56, stack-group 15 =
port 60
2 Insert the optic into the port until it gently snaps into place.
Note: Both rows of QSFP+ ports require that the 40G optics be instered with the tabs facing up.
Note: The S4810 system does not stack with other S-Series systems.
Step Task (Continued)