Force Computers SPARC CPU-3CE, Руководство по установке

Страница: 23 / 49

FORCE COMPUTERS Page 15
SSPARC/CPU-5CE Installation Guide
1.6.2 NVRAM Boot Parameters
The OpenBoot firmware holds configuration parameters in NVRAM. At the Forth Monitor
prompt, type printenv to see a list of all available configuration parameters. The OpenBoot
command setenv may be used to set these parameters.
setenv [configuration parameter] [value]
This information refers only to those configuration parameters which are involved in the boot
process. The following table lists these parameters.
When booting an operating system or another stand-alone program, and neither a boot device
nor a filename is supplied, the boot command of the Forth Monitor takes the omitted values
form the NVRAM configuration parameters. If the parameter diag-switch? is false, boot-device
and boot-file are used. Otherwise, the OpenBoot firmware uses diag-device and diag-file for
booting.
For a detailed description of all NVRAM configuration parameters, please refer to the OPEN
BOOT PROM 2.0 MANUAL SET.
Table 3: Setting Configuration Parameters
Parameter Default Value Description
auto-boot? true If true, boot automatically after power on or reset
boot-device disk Device from which to boot
boot-file empty string File to boot
diag-switch? false If true, run in diagnostic mode
diag-device net Device from which to boot in diagnostic mode
diag-file empty string File to boot in diagnostic mode