QUICK REFERENCE GUIDE
1
Insert Test Strip
Obtain Result and Discard Strip
1. Insert the contact bars end of the test strip into the meter. Push it in firmly until it will go no further.
1.Use a safety lancet
to obtain a drop of blood.
You will only need 0.7
μ
L
for a test.
2. Hold the drop close to the edge of the
test strip and allow the sample to wick
automatically into the absorbent hole.
3. Do not smear blood onto the strip or try
to place blood on top of the strip. When
the absorbent hole is filled, the meter will
start the countdown from 7 seconds.
1. After 7 seconds, the meter
will beep, your blood glucose
result will be displayed
and stored in meter memory.
2. Eject the used test strip by
pushing up the test strip
eject button.
2
Obtain Blood Sample and Apply Sample to Test Strip
3
Customer Service: 888.425.1149
9247 Research Drive Irvine, CA 92618
www.linksmed.com
GD
20
Blood Glucose Monitoring System
Back
Front
The front side of the
test strip should face
up when inserting
the test strip.
3. Clean and/or disinfect the meter following either the
cleaning and disinfecting procedures outlined in the
Operations and Procedures Manual or per your facilities
cleaning protocol.