FOR-A USF-212PS, Руководство по эксплуатации, Страница: 18 / 40

18
5-2. Installing a USF Front Module
IMPORTANT
Make sure to install the front module after installing the rear module.
1.
Slot 1 is the top slot in the right block of the front panel. Refer to Sec. 4-5.
"Slot Number”
2. Set the front module on the guide rail and carefully insert the front module slowly.
PCB Guide Rail Locations
3.
Push the handle until the front module clicks into the connectors.
IMPORTANT

Inserting the module by pressing on other than the handle may damage the module.

When a front module is installed with power on, maximum 1 minute is required until the
module is detected and identified on the web.
PCB Guide Rail PCB Guide Rail PCB Guide Rail PCB Guide Rail