17
6-2. syslog Functions
The USF-1053DDA supports log monitoring and message transmission via syslog protocol.
Clicking the syslog tab opens a window shown as below.
Item
Descriptions
Send syslog
Select
Enable
to send syslog messages to the management terminal.
Send address
Sets the IP address to send syslog messages to. The IP address is the
same as the SNMP trap address. Refer to the USF frame operation
manual for details on setting SNMP trap addresses.
Facility
Sets syslog logging facilities in Local 0 through Local 7.
Header message
Sets syslog header messages up to a maximum of 63 alphanumeric
characters.
Factory setting: USF-1053DDA.
Input video detect
Sets detection messages for video input into USF-1053DDA (maximum
of 63 alphanumeric characters). Sets priority in 9 steps.
Factory setting:
Notice
.
Input video loss
Sets detection messages for input video into USF-1053DDA is lost
(maximum 63 alphanumeric characters). Sets priority in 9 steps.
Factory setting:
Warning
.
*
Click
Apply
when settings are changed.
*
When video signals routed from USF frame internal bus are distributed, , syslog messages are
not sent out.
