11
4-2. Distributing another type module input
This section describes an example of how to route the Slot 4 input to Slot 1 output when
USF-1053DDA is installed in
Slot 1
and USF-1043FS is installed in
Slot 4.
4-2-1. Input Settings via DIP Switch
(1) Set USF-1053DDA DIP switch settings to those shown in the table below and install the
module into
Slot 1
on the USF Frame.
SW1
SW2
SW3
SW4
OFF
OFF
OFF
ON
(2) Install a USF-1043FS into
Slot 4
of the USF frame.
(3) Input a video signal into SDI IN1 of the USF-1043FS in Slot 4.
4-2-2. Input Settings via Web GUI
(1) Install a USF-1053DDA into
Slot 1
and USF-1043FS into
Slot 4
.
(2) Start the Web GUI and set as follows.
<USF-1053DDA>
Set
Slot 4
as the Slot 1 Input Source.
<USF-1043FS>
Go to VIDEO Tab > [Video System] > [System Settings] and set Primary Source as
SDI 1
.
(3) Input a video signal into SDI IN1 of the USF-1043FS in Slot 4.
3G/HD/SD SDI IN
USF-1043FS
1
2
1
2
3
4
3G/HD/SD SDI OUT
SDI IN
1
2
3
4
5
SDI OUT
USF-1053DDA
Slot 1
(USF-1053DDA)
Slot 4
(USF-1043FS)
