12
7. Web GUI
USF-1040VEA or 1100VEA operation can be monitored and network settings can be changed via
web browser/PC-network connection by applying a USF-VEAIF to a USF-1040VEA or 1100VEA
module installed in a USF-212S. SNMP monitoring is also available. Refer to the USF-212S
operation for details on displaying web pages.
NOTE
The USF-1040VEA or 1100VEA does not support simultaneous Web GUI access from
multiple PCs. SNMP Manager should be used to monitor USF-1040VEA or 1100VEA
from multiple PCs.
7-1. Web Page
The USF-1040VEA or 1100VEA web page allows you to show the module status and settings.
As factory default,
Cable Compensation
and
Video Gain
cannot be adjusted from the Web
GUI. To adjust them from the Web GUI, change internal switches (SW3 and SW4) to
REMOTE
on the USF-1040VEA/1100VEA front module.
Refer to Sec. 4
. “Front Module DIP Switch Settings” for LOCAL/REMOTE setting details.
<LOCAL display>
<REMOTE display>
* Same settings apply to the USF-1100VEA.
Module Information
Item
Status Display
Slot
Slot no. of USF-212S on which the module is installed.
S/N(USF-VEAIF)
Serial Number of USF-VEAIF
Version(USF-VEAIF)
Software version of USF-VEAIF
IP Address
IP address of USF-VEAIF
MAC Address
MAC address of USF-VEAIF
Installed Cards
Indicates whether or not the front and rear modules match.
Matched
: Correct (front/rear) modules are installed.
Mismatched
: Incorrect rear module installed. Install correct rear
module.
CPU Temperature
Temperature of the CPU on the USF-VEAIF
Video Input
Video Input Status
Detected
: Normal video input (within -10dB to +6dB)
Not Detected
: No or low level video input. (less than -10dB)
Video Input Trap
Enable
: Sends input status traps to SNMP manager when input
signal changes.
Disable
: Disables input traps.
