10
3. Connection
3-1. Installing to a UFM frame
UFM-30DEMUX and UFM-3DMXAO modules are used by installing them into UF-106B or
UF-112 UFM frames.
UFM-30DEMUX
UFM-30DEMUX modules can be installed in any empty slot on UFM frames.
A UFM-30DEMUX module set consists of a front and rear module. Be sure to always install the
front and rear modules in the same slot positions.
UFM-3DMXAO
Install a UFM-3DMXAO module set into the slot
just below the UFM-30DEMUX slot
.
(1) Attach the gasket supplied with the UFM-3DMXAO on the UFM-30DEMUX card as shown in
the figure below.
Then, connect the UFM-30DEMUX and UFM-3DMXAO front modules with the supplied flat
cable. Bend the flat cable as shown in the figure below.
IMPORTANT
Make sure that when a UFM-3DMXAO is connected to the UFM-30DEMUX, the
supplied gasket is attached to the UFM-30DEMUX card.
(2) After connecting the flat cable, align the two module cards so that the pivot post on the
UFM-3DMXAO card is correctly inserted into the pivot hole of the UFM-30DEMUX card.
Insert the pivot post
into the long hole.
Attach the gasket.
Connect the two front
modules by bending the
flat cable
Back face of UFM-30MUX
front module
Front face of UFM-30MUXAI
front module
USO
RESTRITO
