FOR-A MV-410RGB, Руководство по эксплуатации

Страница: 24 / 36

24 MV-410RGB
6-3. LAN
On the MAIN MENU screen, move the cursor to [LAN] and press the ENTER button. The
LAN screen is displayed as shown below. On the LAN screen network setting can be seen
and changed.
Operating Procedure
Button Action
Moves the cursor up.
Moves the cursor down.
Changes the setting item value. (Reverse)
Changes the setting item value. (Forward)
ENTER
Entering value while pressing down ENTER will change the value of the
10 digit.(Except MASK LENGTH)
MENU Returns to MAIN menu.
IMPORTANT
If the MENU button is pressed when the entered value is invalid, an error message will be
displayed. Press or button to clear the error and correct the invalid value.
Setting Items
Item Setting range Setting details
IP
ADDRESS
0.0.0.0 - 255.255.255.255
(except 0.0.0.0, and 1.0.0.0)
Used to set IP ADDRESS. This setting is
necessary for the communication over a LAN
interface. Please consult with your system
administrator if using in your existing
network.
MASK
LENGTH
0 - 31
Used to set subnet mask length for the
device.
MULTICAST
ADDRESS
239.255.0.0
Displays multicast address to use in
multicast mode. Not used in MV-410RGB.
MULTICAST
PORT
2100
Used to set multicast port for the connection
with the devices in multicast mode.
Not used in MV-410RGB.
GATEWAY 0.0.0.0 - 255.255.255.255
If your network does not have a gateway, this
setting is not required.
MAC
ADDRESS
Do not change
Displays the MAC addresses of the device.
The value cannot be changed.
IMPORTANT
If you change the value for the items other than MULTICAST ADDRESS and MULTICAST
PORT, a warning message appears to require the restart of the unit. Whenever you have
changed these settings, power off the MV-410RGB once and power on again.
LAN
IP ADDRESS 192.168.0.1
MASK LENGTH 24BIT
MULTICAST ADDRESS 239.255.0.0
MULTICAST PORT
2100
GATEWAY 0.0.0.0
MAC ADDRESS 00-10-
Ｂ
1-02-7x-xx
*The settings in the figure above are the factory defaults.