FOR-A HVS-XT100, Руководство по эксплуатации

Страница: 57 / 236

57
7-2. Button Switching Mode in the M/E Bus
Users can change the button switching mode for the M/E bus from P/P (PGM/PST) to A/B. In
P/P mode (default), the source selections in the PGM and PST buses are switched when
transitions occur and users can always select the next background signal from the PST bus (the
bottom row). In A/B mode, the source selections in the PGM and PST buses do not switch when
transitions occur and the next signal selection takes place in the different bus after each
transition.
To Change the Switching Mode to A/B:
(1) Press MENU then SETUP in the SELECT/KEYPAD block to display the SETUP menu top
page. Turn F1 to select PANEL. Press F1 or the page down button to display the [SETUP -
PANEL] menu.
(2) Turn F1 to select TRS CTRL. Press F1 or the page down button to display the [SETUP -
PANEL - M/E CTRL] menu.
(3) Turn F1 to select A/B. Press F1 or ENTER on the keypad to confirm the setting.
PANEL :BUSTYPE: : FADER OFFSET : 1/1
M/E CTRL: =
A/B : :U=1.00 L=1.00 :
7-3. Setting-up and Using the SHIFT Function
Users can select a video signal from 12 sources on the control panel, because each bus row has
12 buttons. The SHIFT function can also be assigned to a bus button in the same way video
sources can. The SHIFT button allows users to select a video signal among 22 sources on the
panel. (The SHIFT button is also available on the KEY/AUX bus.) The SHIFT function is not
assigned to a button by default. To use the SHIFT function, assign it to a bus button as shown in
the procedure below.
7-3-1. Assigning the SHIFT Function to a Bus Button:
(1) Press MENU then SETUP in the SELECT/KEYPAD block to display the SETUP menu top
page. Turn F1 to select INPUT. Press F1 or the page down button to display the [SETUP
- INPUT] menu.
(2) Turn F1 to select ASSIGN. Press F1 or the page down button to display the [SETUP -
INPUT - ASSIGN] menu.
SETUP :>SIGNAL >PROC AMP>RENAME > ASSIGN
INPUT :>COLORBAR
(3) Turn F1 to select a bus button for use.
(4) Turn F2 or F3 to select SHIFT under
SIGNAL .
INPUT :BUTTON : SIGNAL NAME :INHIBIT: 1/3
OU ASGN : =
12 : = SHIFT = SHIFT : =OFF :