FOR-A HVS-XT100, Руководство по эксплуатации, Страница: 41 / 236

41
5-5. Changing the Side Panel Image
The side panel image of 4:3 video can be changed as shown in the procedure below.
(1) Display the [SETUP - INPUT] menu.
(2) Turn F1 to select SIGNAL. Press F1 or the page down button to display the [SETUP - INPUT
- SIGNAL] menu.
(3) To change the side bar color for 4:3 images, press the page down button to go to PAGE3.
(4 Turn F1 to select an input signal to which side panels are to be added.
(5) Turn F2 to set the side panel to ON.
(6) Turn F3 to select an input signal to be used for the side panel. Options are BLACK,
INPUT01-12, STILL1-2, and SDMT. Select SDMT (single color for side panel) for the signal
in this example.
INPUT :SELECT : SIDE PANEL :XPT DLY: 3/4
SIDE PNL: =
IN01 :En= ON S= SDMT : =0 :
(7) Press the page down button to go to PAGE 4 to set the SDMT color.
(8) Turn F4 to select a color from the following 8 standard colors. Then press F4 to apply the
setting. If you want to adjust the selected color or set the color by entering its HSL values.

See section 5-9. "Bus Matte" for details on how to set colors.
5-6. XPT DELAY
The XPT DELAY (crosspoint delay) feature allows you to add a time delay until a signal is
changed after pressing a bus button. To enable the feature, proceed as follows:
(1) Display the [SETUP - INPUT] menu.
(2) Turn F1 to select SIGNAL. Press F1 or the page down button to display the [SETUP - INPUT
- SIGNAL] menu.
(3) Press the page down button to go to PAGE 3.
INPUT :SELECT : SIDE PANEL :XPT DLY: 3/4
SIDE PNL: =
IN01 :En=ON S=SDMT : = 30 :
(4) Turn F1 to select an input signal. Select IN01 in this example.
(5) Turn F4 to set a delay value in frames.
(6) Press IN01 (the bus button to which IN01 is assigned) on the PGM bus. The PGM image is
switched to the IN01 image 30 frames after the bus button is pressed.
IN05 (SD)
(525/59.94i)
COLOR=WHITE