FOR-A HVS-XT100, Руководство по эксплуатации

Страница: 155 / 236

155
18-3. Selecting a Reference Signal
The switcher provides a reference input, its loop-through and output connectors in the
GENLOCK section on the rear panel.
18-3-1. To Set Reference Input
(1) Press MENU in the SELECT/KEYPAD block, then press SETUP to display the SETUP
top menu. Turn F1 to select SYSTEM, then press F1 or the page down button to open the
[SETUP - SYSTEM] menu.
(2) Turn F1 to select REF I/O, then press F1 or the page down button to open the [SETUP -
SYSTEM - REF IN] menu.
(3) Turn F1 to select a reference signal to be input to the switcher between Black Burst and
Tri-level Sync.
(4) Adjust the horizontal phase under H PHS .
SYSTEM : TYPE : H PHS : : 1/2
REF IN : =B_B : =0 : :
18-3-2. To Set Reference Output
(1) Press the page down button in the [SETUP - SYSTEM-REF IN] menu to go to the [SETUP
- SYSTEM - REF OUT] menu.
(2) Turn F1 to select a reference signal to be output from the switcher between Black Burst
and Tri-level Sync.
(3) You can adjust the horizontal phase of the reference signal under H PHS and the vertical
phase under V PHS .
SYSTEM : TYPE : H PHS : V PHS : : 2/2
REF OUT : =B_B : =0 : =0 : :
18-4. Setting Date, Time and Time Zone
(1) Open the [SETUP - SYSTEM] menu.
(2) Turn F1 to select TIME, then press F1 or the page down button to open the [SETUP -
SYSTEM - TIME] menu.
SETUP :>FORMAT >REF I/O >ARCNET >ETHERNET
SYSTEM :>RS-422 >
TIME >INIT >REBOOT
(3) If you need to change the date, press F1 to select Month, Day or Year, then turn F1 to
change the setting.
(4) If you need to change the time, press F3 to select Hour, Minute or Second, then turn F3 to
change the setting.
SYSTEM : DATE(mm/dd/yy):TIME[10:20:10] : 1/4
TIME : =JUL/14/10 : =10:20:20 :
(5) To set the time zone, open [SETUP - SYSTEM - TIME] menu PAGE 2.
(6) Turn F3 to set the time zone offset value.
SYSTEM :1st CHK:SUMMER :TIME ZONE : 2/4
TIME : =OFF : =OFF : =UTC[
9 :00] :