166
18-6. Macro Execution Buttons
18-6-1. Assigning Macros to Bus Buttons
Macros can be assigned to bus buttons in the same way as video signals.
The example below shows how to assign Macro 05 to Bus Button 3, and to execute the
macro.
Assigning Macro 05 to Bus Button 3
(1) Open the [SETUP - INPUT - ASSIGN] (1/6) menu.
(2) Turn F1 to select Bus Button 3.
(3) Turn F3 to select MCR05 (Macro 05).
INPUT :BUTTON : SIGNAL NAME :INHIBIT: 1/6
OU ASSGN: =
03
: =
MCR05
: =MCR00: =OFF :
Executing Macro 05
Press Button 3 on the M/E1, M/E2 or KEY/AUX bus to execute Macro 05. Bus Button 3 on all
bus rows blink while the macro is being executed..
18-6-2. Changing the KEY/AUX Bus Buttons to Macro Buttons
Stored macros can be executed using the KEY/AUX bus buttons and a USER button, to
which the MACRO BUS SELECT function is applied. This chapter shows how to execute
Macro 00
using
USER 3
and
Button 1 on the KEY/AUX
bus as an example.
To Assign the MACRO BUS SELECT function to USER 3
(1) Press USER BUTTON in the CONTROL block above the keypad.
(2) The [USER BUTTON] menu will appear.
(3) Turn F1 to select OU-3. INC (USER 3) on the upper left corner of the keypad will blink.
(4) Turn F2 to select OTHER, then turn F3 to select MACRO BUS SELECT.
USER :SELECT : TYPE : FUNC(F3) : 1/2
BUTTON : =
OU-3
: =
OTHER
: =
MACRO BUS SELECT
To Assign Macros to the KEY/AUX Bus Buttons
(1) Press MACRO in the MEMORY block.
(2) The [MACRO MEMORY] menu will appear. Go to PAGE 3.
(3) Turn F1 to select a button on the KEY/AUX bus. Turn F3 to select a macro to be assigned
to the bus button. (As factory default, Macro 00 is assigned to Button 01 in KEY/AUX, 01
to 02 and so on.)
MACRO :BUTTON : MACRO/NAME : : 3/3
BUS ASGN: =01 : =00 =MCR00 :
To Execute Macro 00 Using Button 1 in KEY/AUX
(1) Press USER BUTTON in the CONTROL block above the keypad
(2) Press INC (USER 3) on the keypad. (The KEY/AUX bus is changed to Macro mode.)
(3) Press 1 in the KEY/AUX busto to perform Macro 00.
