FOR-A HVS-300HS, Руководство по эксплуатации

Страница: 51 / 114

41
10-8-3. User Transitions
A specific transition effect such as Scale Up/Down or Slide In/Out can be set to each ON AIR
button for KEYER, DSK, PinP1 and PinP2. Once a transition effect is set for the ON AIR
button, the effect transition can be executed by simply pressing ON AIR.
To apply the transition effect to ON AIR buttons, proceed as follows.
(1) Press the CLR/TRANS RATE button in the MENU/DIRECT PATT/EVENT/KEYPAD block
to display the TRANS menu.
(2) Press the PAGE DOWN button to go to the page for the desired bus.
(3) Turn F2 to select a transition effect under the
USER TRANS
item. This can be set for
each bus.
TRANS : RATE :USER TRANS :ADV CTL: 2/6
KEYER : =30 : =SLIDE LEFT : =AUTO :
TRANS : RATE :USER TRANS :ADV CTL: 3/6
PinP 1 : =10 : =SLIDE UP : =C/AT :
TRANS : RATE :USER TRANS :ADV CTL: 4/6
PinP 2 : =10 : =CUT : =AUTO :
TRANS : RATE :USER TRANS :ADV CTL: 5/6
DSK : =25 : =SCALER : =C/AT :
Item Setting Description
CUT Performs Cut transition for the bus.
SCALER Performs Scale Up and Down for the bus.
SLIDE RIGHT/LEFT
SLIDE TOP/BOTTOM
Performs Slide In and Out for the bus.
WIPE RIGHT/LEFT
USER
TRANS
WIPE TOP/BOTTOM
Performs WIPE In and Out for the bus.
10-8-4. Advanced Auto Transitions
The function of the AUTO buttons for KEYER, DSK, PinP1 and PinP2 can be set in two
different ways as shown in the table below.
Item Setting Description
KEYER
Always performs AUTO transitions regardless of how
long the button is pressed.
AUTO
DSK,
PinP1, PinP2
Always performs Mix transitions regardless of how long
the button is pressed.
KEYER
Performs Cut transitions when button is briefly pressed.
Performs AUTO transitions when button is pressed and
held down.
ADV CTL
C/AT
DSK,
PinP1, PinP2
Performs Cut transitions when button is briefly pressed.
Performs MIX transitions when button is pressed and
held down.
To Change the AUTO button function:
(1) Open the TRANS menu.
(2) Press the PAGE DOWN button to go to the desired page.
(3) Turn F4 to select a function for the button under the
ADV CTL
item. This can be set for
each bus. (See the menus above.)