User Manual
Thank you for purchasing this Fontastic
®
headphones
„Anca“
with active noise cancellation. Please read the Manual
carefully and observe the safety instructions. Please keep
these operating instructions for future reference.
Package contents
• Fontastic
®
Headphone Anca
• USB charging cable
• 3.5 mm audio cable
• Fabric bag
• This user manual
Overview
1.
Speaker
2.
Height adjustment
3.
Headphone strap
4.
button | Next title
5.
Multifunction button
(On/Off, Telephone,
Musik Start/Stop)
6.
Volume- button | Previous title
7.
3.5 mm Line-in connector
8.
Microphone
9.
Micro USB connector
10.
LED indicator
11.
ANC switch
LED functions
Connected
Blue flashes
Not connected
Blue and red flashing alternately
Incoming call
Blue flashing slowly
Battery charging
Red steady on
Pairing mode
Blue and red flashing alternately
ANC enabled
Green steady on
Charging the battery
The Fontastic
®
Anca is equipped with an internal rechargeable
battery. Connect the Anca with the micro USB cable which is
included in the package contents.
The cable can be connected to a computer or a standard USB
power supply. The Anca‘s red LED lights up during the charging
process. When fully charged, the red LED goes out.
GB
GB
1
2
The cable can be disconnected from the Fontastic
®
Anca.
Note:
Charge Anca for at least 3-4 hours before initial use.
Adjusting the height / turning the speakers
Anca offers the possibility to adjust the loudspeakers in height
to the optimum position for you. To do this, hold the loudspeaker
unit up and pull the headphone strap (3) upwards. Adjust the
headphones in this way until the ear pads are exactly on the ear.
For comfortable wearing around the neck when the headpho-
nes are not being used to listen to music, the speakers can be
turned outwards. The headphone can be folded for space-saving
storage or transport.
Switching On /Off
To switch on
, press the multifunction button (5) for 3 seconds,
an acoustic signal sounds, the blue and red LED flash alternately.
To switch off
, press the multifunction button (5) for 3 seconds,
an acoustic signal sounds,
the LED goes off.
Pairing
Anca must be paired with a Bluetooth
®
device before it can be
used as wireless headphone with hands free function.
1.
In the off state, press and hold the multifunction button (5) for
3 seconds to turn on. Keep the button pressed and wait until
the blue and red LED flashes alternately. This indicates the
pairing mode.
2.
Search for
„Anca“
on your Bluetooth
®
enabled device and
select it from the list of found devices to connect the
headphones to the Bluetooth
®
device.
3.
Confirm the connection with
Anca
.
If you are unsure about the pairing procedure of your Bluetooth
®
device, please check your device manual. When using a
Bluetooth
®
transmitter without display, set it to pairing mode and
wait a few seconds until the connection with Anca is established.
Note:
If the connection is lost or the transmitter is temporarily
disconnected, briefly press the multifunction button. Anca will
then try to restore the connection.
1
2
3
4 5 6
7
8 9 10 11
