![Fona Aquamarine Скачать руководство пользователя страница 63](http://html1.mh-extra.com/html/fona/aquamarine/aquamarine_operating-instructions-manual_2315301063.webp)
Operating Instructions
båÖäáëÜ
cê~å´~áë
63
8.5
Troubleshooting of simple defects
In case of malfunctioning, proceed as follows:
General
First general directions in case of malfunctioning:
● Check if power supply is connected properly and/or rechargeable
battery is loaded.
● Check if UniTip, EndoTip or ActiveTip is installed correctly.
● Be sure that all operational steps have been carried out correctly.
● Check the functioning of the finger switch
The touch screen of the Aquamarine remains dark after switching it on.
● Check the connection of the power cable and/or check the
rechargeable battery.
● Make sure that the switch on the switching power supply is switched
on.
● Check the connection of the interlock device or interlock bridge.
Finger switch
The finger switch is claimed to be broken.
● Check if the plug of the cable is properly connected to the control unit.
Aiming beam
There is no aiming beam.
● Check to see if the single-use fiber tip or light guide or its connector
is damaged. If the single-use fiber tip or light guide is damaged,
replace it with a new one.
● Check the connection of the single-use fiber tip or light guide.
● Check the proper assembly of the handpiece sleeve.
● Be sure that all operational steps have been carried out correctly.
The light of the aiming beam does not project a uniform circular pattern.
● Trim the end of the single-use fiber tip with the fiber cutter. Always
make the notch perpendicular to the optical fiber.
Interlock
The interlock is claimed to be open.
Interlock is used:
● Check the connection of the interlock.
● Check if the door is open.
Interlock is not being used:
● Check if the interlock bridge is connected properly.
Overheating
The laser source is claimed to overheat.
● Check if unit is placed near heat sources. If so, place the unit
somewhere else and let it cool down.
● The laser diode has reached the limit temperature, max. 4 minutes of
continious work at maximum power. Wait until the laser source has
cooled down.
Содержание Aquamarine
Страница 1: ...l f b Operating Instructions...
Страница 2: ......
Страница 76: ...76 Aquamarine...
Страница 77: ......