HARMONY • RIDE Technology
Horizon Elite 710/1010/1410
7
4.
Mount Ice Machine
Mounting options: Cabinet, Wall, Stand
In cabinet
Wall bracket
Stand
4.1
Ice machine in cabinet
Ice machines can be installed undercounter/in-cabinet to fill bins or dispensers using RIDE technology. Care
must be taken to ensure proper cabinet venting to avoid recirculation of hot air. Improper venting can cause ice
machine outages.
DOCKING STATION: Horizon
(See detail drawing on page 8)
§
Position and screw docking assembly to the bottom of counter inside of access panel/door
➊
1010/1410: 2.25" (57 mm) from the front edge of asembly
710: 3.25" (83 mm) from the front edge of the cross brace
§
The mounting surface for the docking assembly must be solid.
Do not mount directly onto runners or channels.
§
There must be no lip or edge that would hinder the ice machine from sliding in or out of the docking station
➋
INTAKE AND EXHAUST GRILLE PLACEMENT: Air-cooled models only
(See detail drawing on page 9)
§
Position the intake grille cut out in the access panel/door
Note: Ice machine must be aligned with cut out and inside of access panel to provide a tight seal and prevent
recirculation of hot exhaust air.
§
Left edge of cutout from the left side of the ice machine
➌
1010/1410: 2.25" (57 mm)
710: 2" (51 mm)
§
Bottom edge of cutout should be 2" (51 mm) from the bottom of the ice machine
➍
§
Position supplied exhaust grille at least 18" (458 mm) away from intake grille
➎
.
Where possible, install exhaust grille to the rear or side of the base cabinet.
§
If not using supplied grille, air circulation requirements below must be met:
1010/1410: 250 sq. in (1613 sq cm) intake/exhaust air
710: 160 sq. in (1032 sq cm) intake/exhaust air
